<form id="vtdnx"></form>

      <form id="vtdnx"></form>

            <form id="vtdnx"></form>

                        Welcome to QuZhou KingKong Machinery Co. , Ltd.
                        Micro heat regeneration adsorption dryer
                        Product introduction

                        Micro Heat Regeneration Adsorption Dryer

                        Working condition and technical index

                        Design pressure dew point: standard type -20℃ (can provide -40℃/-70℃ products)

                        Inlet temperature: 20~45°C

                        Working pressure: 0.6~1.OMpa

                        Desiccant: standard activated alumina, low dew point activated alumina and 5A molecular sieve combination

                        Working mode: Two adsorption cylinders work alternately and continuously

                        Control method: computer program control

                        Air intake oil content: ≤0.1PPM

                        Pressure loss: ≤3% of inlet pressure

                        Regenerative gas volume: ≤6~8%

                        Regeneration method: micro heat regeneration

                        Heater voltage: 1~8Nm3/min, 220V1ONm3/min and above is 380V

                        Work Cycle: 1~20Nm3/min, 120 minutes; 25~50Nm3/min, 240 minutes

                        Technical Parameter of Micro heat regeneration adsorption dryer

                        Micro heat regeneration adsorption dryer.png

                        Micro heat regeneration adsorption dryer supports ASME standard.